Because of the infrared radiation heating pipe and construction materials are unique, Dan Lian Technology recommends that you be sure to remind the relevant personnel at the installation and use of the process before the full understanding of the following:
1. Because of material and structural reasons, the infrared radiation heating of the quartz glass tube and heating wire are at a greater vibration fracture when possible, so when moving and stacking be sure to avoid the greater shock and extrusion.
2. Avoid the use of one hand and hold one end of the heating tube heating of roots trying to get control, because the end of quartz tube (pressure seal Department) by the bending force to break easily.
3. Try to wear soft gloves get and install the heating pipes, oil and perspiration can prevent dirty heating effect of the impact of heating pipe, heating pipe and the installation process in case of fragmentation can be avoided when the operator's hand caused by scratch.
4. Heating pipe at installation to avoid heating of the tube or pipe ceramic head rigid fixation, because infrared radiation even though the thermal expansion of the heating tube is very small, but your device in the heat in the process of deformation may have cause damage to the heating pipe . Please recommend as far as possible, in accordance with the Secretary of the way my installation, or support provided by the use of our dedicated installed Block (two-side heating of the ceramic tube and or the installation of the first between the Freedom Tower with 2 to 3 mm axial gap left at least); if adopt a flexible clamp installation, you should be to ensure that heating controls are not deformed due to heat damage to equipment.
5. If you are using a reflective layer with the heating pipes, the reflective layer should be grateful if you did not want to heat one side towards the workpiece.
6. The installation process, please try to avoid the heating pipe and equipment, tools, etc. bump, bump in particular the end of the heating tube. If the reflective layer with the heating pipes, to install and use in the process of hard objects to avoid scratching, rubbing the surface of reflective layer, in particular, are gold-plated reflector.
7. Some specifications of the heating pipe work has a strong visible light, do not open with the naked eye so as not to cause irritation of the eyes.
8. Not in heating cooling pipes have not yet been fully touch the heating pipes, so as to avoid possible burns.
9. If possible, should try to make two-side heating tube (quartz tube closure pressure Branch) under low-temperature zone (no more than about 300 ℃ appropriate), to extend the life of the heating tube. For example, you can make two-side heating tube to extend your heating equipment or outside of the insulation layer.
10. Heating to maintain the level of control should be installed to extend the service life. If so, what specific requirements need to tilt or vertical installation, please order at my company with the Department of Ministry of Commerce or technical contact.
11. Two-side heating tube pinout power, whether or not there is insulation layer, all suggest that you put in the installation of high temperature ceramic insulation or fiberglass pipe casing in order to avoid the risk of possible leakage.
12. In order to reduce the installation process you are in trouble, it is recommended that you use my company dedicated to provide you with the installation of ceramic blocks or s stainless steel clip.
If you have anything unclear, you can always contact us.